Panasonic AW-RC400N Operating Instructions Manual page 54

Operating procedures
$ Genlock adjustments for the respective cameras
For details on the genlock adjustments, refer to the operating instructions of the AW-CB400 remote operation panel or
WV-CB700A remote control box.
$ Video adjustments for the cameras
Adjust the total pedestal (black level), white balance, black balance, etc. of the cameras.
For details on the camera adjustments, refer to the operating instructions of the AW-CB400 remote operation panel or
WV-CB700A remote control box.
$ Tracing memory settings
Perform these settings on the AW-RP400 pan/tilt control panel.
The AW-RP400 comes with a tracing memory function for registering the paths along which the pan/tilt head systems move.
Using this function, the data is registered in TRACING MEMORY buttons 1 to 10.
Setting the recording time and number of memories
1 Select the first pan/tilt head system using one of the CONTROL SELECT buttons.
2 Set the recording time in the tracing memory and the number of memories using the MEMORY LENGTH menu setting.
MEMORY LENGTH
60s
120s
300s
600s
≥ It is not possible to set MEMORY LENGTH if data has already been registered in the tracing memory.
Before selecting a different setting, delete the registered data in the tracing memory, and then perform the setting.
≥ The recording time and the number of memories cannot be changed in each button in which they are registered.
3 Select the other pan/tilt head systems using the other CONTROL SELECT buttons, and set the recording time and number
of memories for each of the pan/tilt head systems.
Registering the tracing memory data
1 Select the pan/tilt head system using one of the CONTROL SELECT buttons.
When using the AW-CB400 for camera control, select the same number for the AW-CB400.
2 Set the statuses of the pan/tilt head and camera at the start point in the tracing memory.
≥ Decide on the view angle and focus using the PAN, TILT, ZOOM and FOCUS controls.
≥ Select auto iris, manual iris or manual lock using the IRIS [AUTO/MANUAL/LOCK] button.
≥ If manual iris is selected, adjust the iris using the IRIS dial.
≥ Adjust the black level, black balance and white balance using the camera controller.
Setting
60 sec. ! 10 memories (buttons 1 to 10)
120 sec. ! 5 memories (buttons 1 to 5)
300 sec. ! 2 memories (buttons 1, 2)
600 sec. ! 1 memory (button 1)
54