Miele DA 186 Operating And Installation Instructions page 19

Depth adjustment
^ The depth of the unit "T" can be
adjusted from 275 to 360 mm by
means of the adjustable brackets.
^ Slightly loosen the screws on the
brackets.
^ Then pull the brackets out until you
achieve the required depth "T".
^ Tighten the screws up again.
^ To align the depth on the underside
of the appliance, loosen the screws
on the angle plate and move it to the
position required.
^ If this does not provide enough
adjustment, unscrew the angle plate
completely, turn it around and use
the longer side.
^ Tighten the screws up again.
Fitting the rangehood to the wall
^ Cut the drilling template for the wall
fixings to size, and position against
the wall.
The top edge of the template indicates
the top edge of the appliance. It must
be at least H = 1100 mm in order to
comply with the safety height required
above a cooktop or cooker.
^ Mark and drill the four drill holes for
the mounting plates (C 8 mm).
^ Fix the mounting plates to the wall
using the S 8 rawlplugs and
4.5 x 45 mm screws supplied.
A drilling template is provided if you
wish to secure the rangehood to
adjoining wall units, or to fit side panels.
^ Using the template, drill two fixing
holes in the side of the wall unit or the
side panel (C 2 mm).
Installation
19