Introduction
Welcome to OutBack Power Technologies
Thank you for purchasing the OutBack FX Mobile Series Inverter/Charger. This product offers a complete
power conversion system between batteries, shore power, and generator.
12-, 24-, 32-, 36-, and 48-volt models
Output power from 2.0 kVA to 3.6 kVA
Designed to be integrated as part of a full system
using FLEXware™ components
Battery (DC)-to-AC inverting with single-phase
120 Vac output at 60 Hz
Shore power (AC)-to-battery (DC) charging
(FX systems are battery-based)
Rapid transfer between shore power (AC source)
and inverter output with minimal delay time
Uses the MATE™, MATE2™ or MATE3™ System Display
and Controller or the AXS Port™ SunSpec
Modbus Interface (all sold separately) for user interface
Supports the OPTICS RE™ online tool
cloud-based remote monitoring and control application
~
Requires the MATE3 or the AXS Port
~
Visit www.outbackpower.com to download
Uses the HUB4™ or HUB10.3™ Communications Manager (sold separately) for stacking
~
Stackable in series (OutBack or Classic), parallel, series/parallel, and three-phase configurations
Automatic neutral-to-ground bond switching
Listed to ANSI/UL 458 (5th Edition) and CSA 22.2 by ETL
Figure 1
General Safety
Outback Power Technologies Intuitive Control System for Renewable Energy
1
6
for a
1
FX Mobile Series Inverter/Charger with Turbo Fan
WARNING: Limitations on Use
This equipment is NOT intended for use with life support equipment or other medical
equipment or devices.
WARNING: Reduced Protection
If this product is used in a manner not specified by FX product literature, the product's
internal safety protection may be impaired.
CAUTION: Equipment Damage
Only use components or accessories recommended or sold by OutBack Power
Technologies or its authorized agents.
900-0197-01-00 Rev A