Panasonic AJ-SDX900p Operating Instructions Manual page 74

Chapter 6 Maintenance and inspections
5. HUMID
Indications on LCD screen "HUMID" display lights if condensation is
detected.
"HUMID" display flashes for an additional 10 to 90
minutes after condensation detection is canceled.
WARNING lamp Lights for 90 minutes following the release of the
condensation detection after the condensation
formation was detected.
Tally lamp Flashes 4 times per second for 90 minutes after
condensation detection is canceled.
Viewfinder "HUMID"
condensation is detected until 90 minutes after
the condensation detection is released.
Alarm Sounds continuously (4 times a second during
recording).
Warning description Condensation has formed.
VTR unit operation The recording operation continues but if the tape
sticks, recording will stop.
For 80 minutes after the condensation detection is
released, the drum is rotated and no operations
are accepted.
Corrective action Stop the tape travel and turn off the power. If the
"HUMID" displays fails to be cleared even when
the power is turned back on, wait until it clears.
7. RF
Indications on LCD screen "RF" display flashes (during standby and recording).
WARNING lamp Flashes four times a second (during recording).
Tally lamp Flashes four times a second (during recording).
Viewfinder "RF" display lights (during recording).
Alarm Sounds four times a second (during recording).
Warning description The video heads have become clogged. There is
a problem in the video system.
VTR unit operation The cleaning rollers are activated to clean the
heads (for a maximum of 3 seconds).
Recording continues but the signals may not be
recorded correctly.
The indications on LCD screen are retained until
the REC/PAUSE status is established. They go
off as soon as the unit transfers from the
REC/PAUSE mode to another mode.
Corrective action Clean the heads.
recorded correctly even after cleaning, consult
your nearest service center.
9. BATTERY NEAR END
Indications on LCD screen The bar display that shows the remaining battery
charge starts flashing.
WARNING lamp Flashes once a second.
Tally lamp Flashes once a second.
Viewfinder BATT LED starts flashing.
Alarm Sounds four times a second.
Warning description The battery charge is nearly depleted.
VTR unit operation Operation continues.
Corrective action Replace the battery when it becomes necessary.
74
display flashes from the time
If the signals cannot be
6. SERVO
Indications on LCD screen "SERVO" display lights (during recording and
playback).
WARNING lamp Flashes four times a second (during recording
and playback).
Tally lamp Flashes four times a second (during recording
and playback).
Viewfinder "SERVO" display lights (during recording and
playback).
Alarm Sounds four times a second (during recording and
playback).
Warning description The servo is disturbed.
VTR unit operation Operation continues but the unit may not operate
correctly.
Corrective action Turn off the power and consult your dealer. The
warning display may flash for a moment and then
disappear when tape transport commences: this
is normal and not indicative of a failure or
malfunctioning.
8. WIRELESS RF
Indications on LCD screen No indication
WARNING lamp Flashes four times a second (during standby and
recording).
Tally lamp Flashes four times a second (during recording).
Viewfinder "WIRELESS RF" display lights for at least 3
seconds during recording.
Alarm Sounds four times a second (for at least 3
seconds during standby and recording).
Warning description Poor wireless signal reception.
VTR unit operation Operation continues but the signals from the
wireless microphone cannot be received.
Corrective action Check the microphone's power supply and the
reception condition of the receiver.
10. TAPE NEAR END
Indications on LCD screen The bar display that shows the remaining tape
amount starts flashing.
WARNING lamp Flashes once a second (during recording).
Tally lamp Flashes once a second (during recording).
Viewfinder ≥ The remaining tape display starts flashing (in
the EE mode).
≥ " = " flashes for 3 seconds one minute before
the tape reaches the end.
Alarm Sounds once a second.
Warning description The tape is close to its end (about 2 minutes
remain).
VTR unit operation Operation continues.
Corrective action Replace the cassette tape when it becomes
necessary.