Kubota Z482-E3 Operator's Manual page 17

6 OPERATING THE ENGINE
[D1005-E3, D1105-E3, D1105-TE3, D1305-E3, V1505-E3,
V1505-TE3]
(1) Speed control lever
(2) Engine stop lever
[D1503-M-E3, D1703-M-E3, D1803-M-E3, V2003-M-E3,
V2203-M-E3, V2403-M-E3, V2403-M-T-E3, D1803-M-DI-E3,
V2403-M-DI-E3]
(1) Engine stop lever
(2) Speed control lever
(A) "IDLING"
(B) "OPERATION"
(C) "START"
(D) "STOP"
(A) "STOP"
(B) "START"
(C) "IDLING"
(D) "OPERATION"
[V3600-E3, V3600-T-E3]
(1) Speed control lever
(2) Engine stop lever
4. Insert the key into the key switch and
turn it "ON".
(A) "SWITCHED OFF"
(B) "OPERATION"
(C) "PREHEATING"
(D) "STARTING"
5. Turn the starter switch to the
"PREHEATING" position to allow the
glow lamp to redden.
(with lamp timer in use)
A The glow lamp goes out in about 5 seconds when
the lamp timer is up. Refer to this for pre-heating.
Even with the glow lamp off, the glow plug can be
pre-heated by turning the starter switch to the
"PREHEATING" position.
(A) "IDLING"
(B) "OPERATION"
(C) "START"
(D) "STOP"
(A) "PREHEATING"
(B) "SWITCHED OFF"
(C) "OPERATION"
(D) "STARTING"