To Connect The P2 Drive To A Personal Computer For External Use - Panasonic AJ-PCD20E Operating Instructions Manual

Installation
(continue)

To Connect the P2 drive to a Personal Computer for External Use

1
Attach the rubber feet to the dimples on the
base of the P2 drive.
Dimples
2
Start the personal computer.
3
Plug the AC adapter supplied with the P2
drive into the DC IN 16V socket on the P2
drive.
The P2 drive will start.
USB 2.0 IEEE 1394b
DC IN 16V
DC IN 12V
4
(To be connected by USB 2.0)
Plug a USB 2.0 cable B connector into the
USB connector on the P2 drive. then plug the
other end (A connector) of the USB 2.0 cable
into the USB 2.0 port on the personal
computer.
USB 2.0 IEEE 1394b
USB 2.0 connector
<Note>
No USB 2.0 cable is supplied with the P2
drive in the package. Use a commercially
available USB 2.0 cable (shielded).
Take care to use a USB cable that is no
longer than 3 metres. The P2 drive may not
operate properly with a cable longer than 3
metres.
For Macintosh, USB 2.0 operations are not
guaranteed.
DC IN 16V
DC IN 12V
E-8