Drive Motor Removal And Installation - Panasonic JU-475-4 Service Manual

12.10 Drive Motor Removal and Installation
When the carriage is on an inner-most track:
When the carriage is on an outer-most track:
Fig.12-10 Drive Motor Removal
(1) Remove the cartridge gu ide assembly as
described in section 12.7.
(2) Remove the three drive motor mounting
screws and take off the drive motor from the
base.
(3) Reverse the above procedure to reinstall.
(4) After reinstallation, the adjustments necessary
upon reinstallation of the cartridge guide as
described in section 12.7.
c:::)
Outer-most
..._ - - track
Inner-mos~
track
~
Provide a clearance of about
1-
mm between the Side 0 and Side
1
approximately within this
range.
Provide a clearance of about 1-
mm between the Side 0 and Side
1 approximately within this
range.
Align the center with line A. - - - - 0
lineA
Line B
Fig.12·9·2 Pail Tail Leading
·20·