To Mount The P2 Drive In A Personal Computer 5-Inch Bay - Panasonic AJ-PCD20E Operating Instructions Manual

Installation
(continue)

To Mount the P2 drive in a Personal Computer 5-inch Bay

1
Turn OFF the personal computer's power.
2
Undo the six screws and remove the cover.
USB 2.0 IEEE 1394b
3
Mount the P2 drive in a 5-inch bay on the
personal computer. Use the screws supplied
with the P2 drive for mounting.
Please refer
instruction manual
mounting to 5-inch bay drives.
Holes for securing the screws
(the other side is the same.)
<Notes>
The P2 drive may not be able to be
fastened securely in some types of
personal computers.
If all 5-inch bays are occupied, you will
need to remove one of the built-in drives to
make room for the P2 drive.
The P2 drive should be used in a personal
computer whose design allows the front
panel of the Drive to be manipulated.
DC IN 16V
DC IN 12V
to your computer's
for guidance
4
Plug a USB 2.0 cable B connector into the
USB connector on the P2 drive. then plug the
other end of the USB 2.0 cable into the USB
2.0 port on the personal computer.
USB 2.0 IEEE 1394b
USB 2.0 connector
<Note>
USB 2.0 connector pinouts vary according to
the type of motherboard type. Check your
computerís
purchasing a commercially available USB
2.0 cable (shielded).
in
5
Connect the P2 drive to the internal power
cable (4 pins) of the personal computer.
USB 2.0 IEEE 1394b
DC IN 16V
DC IN 12V
instruction manual
DC IN 16V
DC IN 12V
Power cable
before
E-10