DCS HBD1200E Installation Instructions Manual page 26

Remote blower electrical connection
Remove the cover from the remote blower, then remove the wiring box cover.
● ●
Pull the electrical wiring through the hole in the blower base and secure it
● ●
according to local codes using a suitable UL listed strain relief or conduit fitting
(not included).
Connect the N (neutral) wire to the white wire in the wiring box with twist-on
● ●
connector Fig.28.
Connect the L1 (live) wire to the black wire in the wiring box with twist-on
● ●
connector Fig.28.
Connect the green power supply ground wire to the green ground screw.
● ●
Attention – verify that the main filter, flap and wiring box cover are positioned
correctly with wiring clearance.
Replace the wiring box cover and screws taking care not to pinch the wiring
● ●
under the wiring box cover.
Reinstall the remote blower cover.
● ●
24
INSTALLATION INSTRUCTIONS
GREEN -YELLOW
Fig.28
Downdraft wiring
Twist-on connectors
Motor wiring