DCS HBD1200E Installation Instructions Manual page 27

Complete the installation
8
Place the top trim onto the downdraft unit.
● ●
Push the power button on the top trim, the downdraft unit will rise. (The blower will
● ●
begin to vent immediately if the blower control slider is set to an 'On' position).
Remove the labels, screw and brackets as shown in Fig.29. These brackets are used to
● ●
hold the grease filter microswitches in place during transportation. They are located at
the top of the downdraft unit in the centre behind each grease filter.
Connect the top trim to the downdraft unit by threading the 9/32" (7 mm) nuts onto
● ●
the top trim screws Fig.30.
Install the grease filters Fig.31.
● ●
Check the blower operation. If the blower does not work refer to the 'Troubleshooting'
● ●
section on page 28.
5/16" (8 mm)
Fig.32
Attach the ducting
9
For the internal blower box, use 6" (152 mm) round ducting and the 6" (152 mm)
● ●
diameter back draft damper.
For the remote blower, use 10" (254 mm) round ducting.
● ●
Attach ducting using clamps or aluminum duct tape to seal all joints and vent outside.
● ●
Remove packaging
!0
Remove all packaging and protective wrappings.
● ●
Install the cooktop
!1
Install the cooktop according to the manufacturer's instructions.
● ●
Check to make sure that the rear edge of the cooktop overlaps the front edge of the
● ●
downdraft unit by 5/ 1 6" (8 mm) Fig.32.
INSTALLATION INSTRUCTIONS
The internal or remote blower
can alternatively be mounted
on the back of the appliance
EN
Fig.29
Fig.30
Fig.31
25