DCS HBD1200E Installation Instructions Manual page 19

Internal blower installation in one of the following three options:
Option 1: Internal blower, front installation for venting left, right or down
Disconnect the cable from inside the downdraft unit. Plug in that same cable
● ●
from the downdraft unit into the internal blower Fig.7.
Turn the venting collar on the internal blower box to the desired direction – left,
● ●
right or down.
Mount the internal blower box to the housing using four screws Fig.8.
● ●
Continue to the 'Prepare for electrical connection' section on page 21.
● ●
Fig.7
Option 2: Internal blower, front installation for venting to the rear
When venting to the rear with the internal blower mounted on the front of the
● ●
downdraft unit, repositioning of the blower box is required.
Remove the two screws and take the blower out of the internal blower box Fig.9.
● ●
Remove the small cover on the back of the downdraft unit Fig.10.
● ●
Mount the blower on the front of the downdraft unit using two screws while
● ●
positioning the vent collar in the opening of the cover Fig.11.
Fig.9
INSTALLATION INSTRUCTIONS
Fig.10
Fig.8
Fig.11
EN
17