Prepare for electrical connection
6
Downdraft unit
Remove the cover of the terminal box from the downdraft unit Fig.21.
●
●
Decide whether the power source should enter the downdraft unit from below or
●
●
from the back and remove the respective knock out. Install a UL listed strain relief or
conduit fitting (not included) in the knock out Fig.22.
If the downdraft unit is being installed with a remote blower, remove the knock out
●
●
for the control cable.
With the assistance of another person, lift the downdraft unit into the prepared cutout in
●
●
the cabinet. The over counter mounting brackets should rest on the countertop.
Secure the downdraft unit to the floor and countertop with screws into the previously
●
●
drilled holes Fig.23.
Fig.21
Push the end caps into place on the downdraft unit on top of the counter and lock
●
●
them in place Fig.24.
INSTALLATION INSTRUCTIONS
Fig.22
Fig.24
Fig.23
EN
6 x
2 x
21