American Audio VMS5.0 User Manual And Reference Manual page 12

FrONT pANEL - gENErAL FUNCTIONS ANd CONTrOLS
23 24 25 26 26 26 26 29 31 32 33
27 28 27 30
FRONT PANEL -
MIC SECTION (23-25) - the VMS5.0 is equipped with 2 microphone inputs, easy to use, no ASIO
routing required. Each microphone channel has an independent on/off switch, gain control, and 3
band EQ.
23. MIc on/oFF - Turns the corresponding microphone on/off. When you Mic is on the button will
be backlit by a red LED.
24. MIC gAIN CONTROL - Increase or decrease the microphone output.
25. MIC EQ - Adjust the treble, mid, and bass on the corresponding Mic inputs.
MIXER CONTROLS (26-27) - the VMS5.0 can be used as a MIDI control, a stand alone mixer, or
combination giving you maximum control of your music collection whether it be on vinyl, digital CD's
or Computer DJ software (Virtual DJ included).
26. USB/anaLog SWITcH - These will switch the corresponding Channel from USB audio stream
or analog audio input. USB will route the software assigned ASIO audio channel thru the corre-
sponding MIDILOG channel. Analog will route the analog audio input from the rear panel thru the
corresponding MIDILOG channel.
27. cF aSSIgn a & B - CF Assign A will select the desired channel to the left side of the crossfad-
er.* CF Assign B will select the desired channel to the right side of the crossfader.*
* Normal Mode: This will be the opposite when the crossfader is reversed.
* The CROSSFADER will only effect a channel's volume when the channel is assigned.
Interface Mode (28-30) - the VMS5.0 can be used as a MIDI control, a stand alone mixer, or com-
bination giving you maximum control of your music collection whether it be on vinyl, digital CD's or
Computer DJ software (Virtual DJ included).
28. 4 oUT: 4 oUT X 4 In USB - Sets MIDILOG channels 2 & 3 to receive audio from software with
ASIO outputs and sends audio or control tones from the channel 2 & 3 RCA inputs to your software
ASIO inputs.
8 oUT: 8 oUT X 2 In USB - Sets 4 MIDILOG channels to receive audio from software with
ASIO outputs and sends the audio from the master output via USB for recording.
29. noRMaL/REvERSE - Switches the crossfader from normal to reverse mode. In reverse mode
the CF A assignments will be on the right of the crossfader and the CF B on the left.
30. cURvE knoB - This knob will adjust the curve of the crossfader from mix curve, dipped curve,
to scratch curve.
American Audio - www.americanaudio.us - VMS5.0 Instruction Manual Page 12
© ®