Liebert NXC
1. It is recommended to use 0.82mm
2. If the switch you have configured is of electronic control tripping function, when the REPO signal takes action, you need to close the
switch before restart the UPS.
7.3 Connecting USB Communication Cables
The USB port is located on the rear panel of the UPS, as shown in Figure 1-3.
The USB port can connect the monitoring software.
The methods to connect the communication cable are as follows:
Insert one end of the USB communication cable to the USB port (see Figure 1-3) on the rear panel of the UPS, and connect the
other end to the USB port of the computer.
After the connection, you need to install the USB drive program in the installation disk.
User Manual 10H52188UM60 - Rev. 2 - 09/2012
2
2
~ 0.33mm
(signal cable of 18AWG ~ 33AWG) copper core cable.
Note
Communication
57