Cleanup - WAGNER Home Decor Owner's Manual

Cleanup

h Before you begin
When cleaning, use the appropriate cleaning
solution (warm, soapy water for chalk-type paint,
milk paint, and latex materials; mineral spirits for
oil-based materials)
IMPORTanT: never clean air cap or air holes
in the nozzle with sharp metal objects. Do not
use solvents or lubricants containing silicone.
note: For basic, quick-cleaning between color changes, fill the material
container with cleaning solution and spray cleaning solution through the gun
into a waste container.
1
2
3
Groove
© Wagner Spray Tech. - All Rights Reserved
note: For a video showing cleanup of the Home
Décor Sprayer, visit www.homedecorsprayer.com.
• Area must be free of flammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
(c)
Tab
Notch
Special cleanup instructions for use
with flammable solvents (must have a
flashpoint above 100ºF (38ºC):
1. Turn turbine OFF.
Remove the container and empty any
remaining material.
Thoroughly rinse the material
container with warm, soapy water (or
mineral spirits for oil-based materials).
2. Disassemble the spray gun and clean
all parts with warm soapy water (or
mineral spirits for oil-based materials).
note: If clogging occurs, make sure the
air vent hole (c) on the suction tube is
cleaned thoroughly.
3. Reassemble the spray gun.
note: When replacing the nozzle seal,
make sure the groove in the seal is
facing outward.
note: Make sure the tab in the spray
gun head is aligned with one of the
notches in the nozzle.
English
7