Connecting A Digital Television And Vcr - Panasonic DMR-BW500 Operating Instructions Manual

Connecting a Digital television and VCR

To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(included)
6 Connect only after all other
connections are complete.
A C IN
This unit's rear panel
Cooling fan
Connect the unit directly to the television
If you connect the unit through an AV selector or
video cassette recorder to the television, video
signal will be affected by copyright protection
systems and the picture may not be shown
correctly.
When connecting to a television with a built-in
VCR
Connect to the input terminals on the television
side if there are both television and VCR input
terminals.
Television's rear panel
Other connections
(➡ 17, 94)
COAXIAL
L A N L AN
DIGITAL DIGITAL
(PCM/BITSTREAM) (PCM/BITSTREAM)
10BASE-T/
AV OU V OUT 100BASE-TX
Audio/Video cable
Connecting to a television with 21-pin Scart terminal
You can also connect with the AV1 terminal on this unit using the 21-pin
DO NOT
Scart cable.
If your television is equipped with RGB input capability, by connecting with
Television
a fully wired 21-pin Scart cable you can see video using RGB output on
this unit.
[Required]setting]
VCR
"AV1 Output" in the Setup menu (➡ 88)
Connecting to a VCR with 21-pin Scart terminal
This unit
You can also connect with the AV2 terminal on this unit using the 21-pin
Scart cable.
[Required]setting]
"AV2 Input" in the Setup menu (➡ 88)
AUDIO IN VIDEO IN
R L
Red White Yellow
5
P
R P B
Red White Yellow
OPTICAL
A V 1
( TV )
AUDIO OUT AUDIO OUT
R- A UDIO- L VIDEO
A V2 ( EXT )
Red White Yellow
4
Red White Yellow
VCR's
rear panel
R L
AUDIO OUT VIDEO OUT
To the aerial
Aerial
cable
Splitter
VHF/UHF
RF IN
3
Aerial cable
1
Audio/Video cable
(included)
Y
COMPONENT COMPONENT
RF RF
VIDEO OUT VIDEO OUT
IN IN
RF RF
OUT OUT
S VIDEO
2
RF coaxial cable
(included)
RF OUT
VHF/UHF
RF IN
RQT9131
97