Kärcher HD 10/25-4 S User Manual page 20

Recommended cleaning method
 Spray the detergent sparingly on the dry
surface and allow it to react, but not to dry.
 Spray off loosened dirt with the high-pres-
sure ray.
 After operations, dip the filter in clear water.
Turn the dosing valve to the highest deter-
gent concentration. Start the appliance and
rinse for one minute.
Interrupting operation
 Release the lever of the hand-spray
gun; the device will switch off.
 Release again the lever of the hand-
spray gun; the device will switch on
again.
Operational readiness period
On opening the hand-spray gun, the device
starts within the readiness period. The indi-
cator lamp glows green.
The readiness period is over if the hand-
spray gun remains closed for 30 minutes.
The indicator lamp blinks green.
Reset readiness period
 Set the appliance switch to "0".
 Wait for a while.
 Set the appliance switch to "I".
Customer Service can switch the device to
continuous operations.
Turn off the appliance
 Set the appliance switch to "0".
 Disconnect the mains plug from the
socket.
 Shut off water supply.
 Activate hand spray gun until device is
pressure-less.
 Press the safety lever of the hand-spray
gun to secure the lever of the pistol
against being released accidentally.
Danger
Danger of scalding by means of hot water.
The water remaining in the switched off de-
vice can get heated up. When you remove
the hose from the water inlet, the heated
water can spray out and cause scalding.
Remove the hose only when the device has
cooled down.
20
Storing the Appliance
 Insert the hand-spary gun in the holder.
 Wind up the high-pressure hose and
hang it over the hose storage.
or
Wind up the high-pressure hose on the
hose drum. Push in the handle of the
crank to block the hose drum.
 Wind the connection cable around the
cable holder.
Frost protection
Warning
Frost will destroy the not completely water
drained device.
Store the appliance in a frost free area.
If you cannot store it in a frost-free
place:
 Emptying the detergent tank (see "Care
and Maintenance/ as required").
 Drain water.
 Pump in conventional frost protection
agents through the appliance.
Note
Use normal glycol-based anti-freezing
agents for automobiles.
Observe handling instructions of the anti-
freeze agent manufacturer.
 Operate device for max. 1 minute until
the pump and conduits are empty.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Pull the device behind you at the handle
for transporting it over longer distances.
 Empty the detergent tank before trans-
porting in horizontal position.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
– 6
EN
Transport