Table of Contents
Advertisement
Troubleshooting
Display
is displayed.
is displayed.
is displayed.
Symptom
Systolic or diastolic blood
pressure value is high or
low.
Value is different from
that measured by the
doctor.
Measurement values are
different with each
measurement.
33
English
Status before error
The indication disappears in
the middle of the operation.
(the
or
mark is
displayed.)
Pressurization to more than
80 mmHg was performed.
The
mark flashes for
minutes or longer.
Pressure decreased
suddenly.
The heart mark
only a few times or not at all.
Cuff does not inflate.
Your arm or body moved.
Failure of the main unit
•
The position of the main unit is higher or
lower than your heart when measuring.
•
Your arm was not inserted properly into the
main unit.
•
You moved or talked during measurements.
(See pages 15–18.)
•
Blood pressure varies in response to minute
changes in your mental state, such as your
reaction to a doctor's presence.
•
Sit quietly for 4 to 5 minutes and then take
another measurement. (See pages 15–18,
30–31.)
Cause and solution
Batteries are exhausted.
(See pages 11–13.)
Were measurements taken
according to the proper
procedure and in the
correct posture?
(See pages 15–18.)
Be sure your arm is
blinked
properly inserted into the
main unit.
(See pages 15–18.)
Has the unit detected
movement?
(See page 0.)
Take it to the store where it
was purchased for testing
and repairs.
Possible cause
Hide quick links:
Advertisement
Table of Contents
