Installing The Propellers; First Flight - GRAUPNER Alpha 300 Q Manual

Installing the propellers

WARNING
!

First flight

First flight in Attitude mode!
Battery connection
16530.HOTT_jh_V1
Risk of injury by rotating propellers when starting the motors.
Always unplug the XT-60 connector to the LiPo battery before
working on the propeller.
Install the propellers as shown in the picture below. Pay atten-
tion to install the proper propeller to each motor. The propeller
rotation sense is written on the propeller (R/L)! The image repre-
sents the copter seen from the top.
3D Prop 6x3 White propeller, R+L (front 1+2)
3D Prop 6x3 Red propeller, R+L (back 3+4)
1 = Clockwise motor
propeller (.L)
1
4
4 = Counter-clockwise motor
propeller (.R)
Switch the transmitter on and plug the battery to prepare the
copter to fly.
Choose a wide area for your first flight. We suggest to select first
the flight mode, because the copter is thus easier to control and
it is easier to become familiar with the flight characteristics of 3D
Copter. Proceed carefully and responsibly.
The built-in voltage module with SBEC offers the possibility to
adjust up to three different voltage warnings in 0.1V steps. Refer
to the instructions supplied with the module and the manual for
your HoTT transmitter.
2 = Counter-clockwise motor
propeller (.R)
2
3
3 = Clockwise motor
propeller (.L)
11 / 16