c) Prevent unintentional starting. Ensure the GENERAL POWER TOOL SAFETY switch is in the off position before connecting to WARNINGS power source and/or battery pack, picking up or carrying the tool. WARNING Carrying power tools with your fi nger on the switch Read all safety warnings and all instructions.
b) Use power tools only with specifi cally In the cases of 1 to 3 described below, when using this designated battery packs. product, even if you are pulling the switch, the motor may Use of any other battery packs may create a risk of stop.
Number of strokes at no load 2500 /min Minimum cutting radius 40 mm Width of nibbling groove 5 mm Weight 2.1 kg (BSL1850) NOTE Due to HITACHI’s continuing program of research and development, the specifi cations herein are subject to change without prior notice.
Page 5
CHARGING Battery and battery charger are not included with this product. Before using the power tool, charge the battery as follows. 1. Connect to the power source. (Fig. 2) Fig. 12 When charging the battery from an AC power source ○...
(every second), please take the <UC18YML2> charger to the Hitachi Authorized Service Center. Especially, using a DC 12 V in-car power source may require longer recharging time at high temperatures.
NOTE When replacing the carbon brush with a new one, be sure to use the Hitachi Carbon Brush Code No. 999054. 5. Replacing carbon brushes (Fig. 11) Take out the carbon brush by fi rst removing the brush cap and then hooking the protrusion of the carbon brush with a fl...