Lid Handle Bezel - Dyna-Glo DGA480BSN User Manual

ASSEMBLY INSTRUCTIONS
7. Slip main burner control knobs (M) and side
burner control knob (N) onto the valve stems
located on the front control panel of the grill
body (O). Remove 2 preassembled M6x25
screws (HH) from the lid handle (U). Attach
the lid handle (U) by inserting two screws from
inside the lid of the grill body (O), through the
lid handle bezels (V), into the handle (U) and
tightening securely.
Hardware Used
HH
M6 x 25 Screw
8. Lock the back two casters to ensure the cart
doesn't move. Carefully place the grill body (O)
over the mounting tabs on the cart side panels
(D and E) and onto the cart. Adjust the grill
body (O) so that the holes in the grill body (O)
are aligned with the holes in the tabs of the cart
side panels (D and E). NOTE: Make sure the
natural gas hose drops inside the cart and exits
through the opening in the cart rear panel (F).
Secure the grill body (O) using 2 M6x20 screws
(EE) on each side.
Install the natural gas hose holders (Z) by
removing the 4 M4x10 screws (DD) from the
predrilled holes in the the bottom shelf (A),
aligning the natural gas hose holders (Z) with
the predrilled holes and over the natural gas
hose, then tighten the screws.
Hardware Used
EE
M6 x 20 Screw
DD
M4 x 10 Screw
(preassembled)
7
x 2
8
x 4
x 4
10
U
HH
M
N
TT
O
EE
D
F
Natural gas
tube opening
DD
Z
V
O
E
DD
Z