Panasonic KX-TCD515E Operating Instructions Manual page 58

Base Unit Settings
Call Options
To exit the operation, press
1
Press JOYSTICK
(or move).
4
Select "Call Option".
Selecting the Flash/Earth Mode
An earth relay can be installed as an option depending on your PBX requirements.
Please consult our Panasonic Customer Care Helpline for installation. On installation,
you can then select the flash or earth mode to suit your PBX or network provider.
Follow steps 1 to 4 shown above, then:
5
Select "Recall".
When "Flash" was selected;
7
Select desired flash type. (see below)
• The factory preset is "Flash".
• "Type 1": 700 ms, "Type 2": 80 ms, "Type 3": 400 ms. The factory preset is "Type
2".
Selecting the Pause Time
You can select the pause time to 3 or 5 seconds, depending on your PBX requirements.
Follow steps 1 to 4 shown above, then:
5
Select "Pause Time".
• The factory preset is "Short".
58
at any time.
2
Select "
Setting
Base".
6
Select "Flash" or "Earth".
6
Select "Short" (3 sec.) or "Long" (5 sec.).
3
Enter 4-digit Base
Unit PIN.
(Factory Preset 0000)
Go to step 5.