Use Philips Easylink; Parental Menu - Philips 40PFL5670/V7 User Manual

Table of Contents

Advertisement

• [
Standby Mode
] :
Set
the function as
• [ARC] : If you connect ARC enabled
Home Theater to TV, set ARC to ON
to listen sound through Home Theater
• [MHL] : To use MHL function set this to ON.
• [MHL
Charge : To use MHL Charge function
]
set this to ON.
[Software Update] :
This option is for updating the software.
• [Reset] : Reset to factory default settings.
Note
EasyLink Applicable for only HDMI Source.
MHL is supported in HDMI 4.
ARC is supported in HDMI 2, If ARC is set to
On,ARC HT is connected then TV Speaker will
Be disabled.

4.11 Parental Menu

Child Lock
Picture
Sound
Installation
Features
Parental
Press
1
2 Select [Setup] > [Parental]
then press OK
3
Select one of the following settings.
then press OK.
• [Child Lock]: Enter the password, then
the following menus will open.
Note: Default password is "0000"
[Child Lock Switch]:Make the child lock
switch ON to lock the source/channel.
EN 14
[Change Password]: Select this option
to change the password.
. .
[Channel Block]: Select the channels to
.
to be locked and press '2' to lock or
.
.
unlock the channels.
[Video Lock]: Select the sources
with up/down keys on remote and press
OK to set or clear lock.
[Clear All]: Reset the child lock
option to default value.

4.12 Use Philips EasyLink

Get the most out of your HDMI-Consumer
Electronic Control (CEC) compliant devices
with Philips EasyLink enhanced control
features.
If your HDMI-CEC compliant devices are
connected through HDMI, you can control
them at the same time with your TV remote
control.
To enable Philips EasyLink, you need to:
Connect HDMI-CEC
compliant devices through HDMI
Configure each HDMI-CEC compliant
device properly
Switch on EasyLink
Note
The EasyLink-compliant device must be
switched on and selected as the source.
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.
4.13 Switch on or off EasyLink
1
Press
2
Select [Setup] > [Features] >
[EasyLink] > [
EasyLink]
.
3
Select [On] or [Off] , then press OK
Note
If EasyLink is OFF, all its submenus are
unavailable.
]

Advertisement

Table of Contents
loading

Table of Contents