Table of Contents
Advertisement
Recording Menu
Note
Make sure that the USB storage device has
been well connected.
When parental control is activated,
schedule recording may not be able to
function properly.
Program recording
In digital TV mode, press
recorder menu on the screen and start program
recording. Press the / key to select the
operation menu and press OK key to confirm.
During recording, you can press keys such as
,
to carry out shortcut operation.
Use Philips EasyLink
With Philips EasyLink you can operate a
connected device with the TV remote control.
EasyLink uses HDMI CEC (Consumer
Electronics Control) to communicate with the
connected devices. Devices must support
HDMI CEC and must be connected with an
HDMI connection.
To enable Philips EasyLink, you need to:
Compatible device can work normally.
Switch to EasyLink.
Note
The EasyLink compatible device must be
turned on and selected as a source.
Philips doesn't ensure 100%
interoperability with all HDMI-CEC
devices.
Turn on or off EasyLink
Note
Do not enable Philips EasyLink if you
don't intend to use it.
1. Press
key.
2. Select TV Settings > EasyLink > EasyLink.
key to display the
,
3. Select OFF or ON and then press OK key.
Set HDMI-Audio Output
1. Press
2. Select TV Settings > EasyLink > HDMI –
Audio Output.
3. Select OFF or ON and then press OK key.
Use EDID
1.
Press
2.
Select TV Settings > EDID Version and
then press OK key to enter.
3.
Select your needed version and then press
OK key to confirm.
Tip
EDID is a data structure provided by a
digital display to describe its capabilities
to a video source.This settings is valid
only under HDMI source.
HDMI EDID1.4 support to 3840x2160
30Hz.
HDMI EDID2.0 support to 3840x2160
50Hz/60Hz, e.g. 4K Blu-ray Player.
Use Timer
You can use Timer so as to switch the TV to
standby after the specified time.
Use Sleep Timer
Set the time when the TV is switched to standby.
Tip
You can switch off the TV or reset the
Sleep Timer before the timer reaches
zero.
1. Press
Sleep Timer.The Sleep Timer is shown on
the screen.
2. Set the timer to a value between 0 to 240
minutes.The increment of the Sleep Timer is
EN 12
key.
key.
key and then select TV Settings >
Advertisement
Table of Contents
