Using Philips Easylink - Philips 22PFT54 3 Series User Manual

• VGA cable
VGA
AUDIO IN
VGA / DVI

Using Philips EasyLink

Making full use of your Philips EasyLink HDMI-
CEC compatible devices can enhance control
features to achieve the best possible results.
HDMI-CEC compatible devices connected
through the HDMI connector can be controlled
by a TV remote control.
To enable Philips EasyLink, you will need to:
• Connect two or more HDMI-CEC
compatible devices using HDMI
connections.
• Make sure that each HDMI-CEC
compatible device is operating normally.
• Switch to EasyLink.
Note
•
EasyLink compatible devices must be switched on and
selected as a signal source.
•
Philips does not guarantee 100% interoperability with
all HDMI-CEC devices.
EN
18
Enabling or disabling EasyLink
Once an HDMI-CEC compatible device has
been switched on, the TV will automatically turn
on and switch to the correct signal source.
•
Do not enable this function if you would prefer not to
use Philips EasyLink.
VGA
1
Press
enter the [Setup] menu.
2
Press
[HDMI CEC].
3
Select [Off] or [On], then press OK.
Using One-touch Play
1
Once EasyLink has been enabled, press
play on the device.
» The TV will automatically switch to the
Using One-touch Standby
1
Press (Standby/On) on the remote control.
» The TV and all connected HDMI
Note
(Home) and select [Setup] to
to select [EasyLink] >
correct signal source.
devices will automatically enter standby
mode.