Service Tire Monitor - Chevrolet 2006 Avalanche Owner's Manual

SERVICE TIRE MONITOR

This message will be displayed if any of the tire monitor
sensors have malfunctioned, if the tire monitor sensors
have not been programmed or if the recommended
tire pressures are not programmed. See your GM dealer
for service. Pressing any of the four DIC buttons will
clear the message from the DIC display. If your vehicle
does not have the four DIC buttons, pressing the trip
odometer reset stem will clear the message from
the DIC display.
STABILITY SYS (System) ACTIVE
You may see the STABILITY SYS ACTIVE message on
the DIC. It means that an advanced computer-controlled
system has come on to help your vehicle continue to
go in the direction in which you are steering.
For more information on the StabiliTrak
®
StabiliTrak System on page 4-9.
STABILITY SYS (System) DISABLED
The STABILITY SYS DISABLED message will turn on
when you press the StabiliTrak
stability control has been automatically disabled. There
are four conditions that can cause this message to
appear.
•
•
•
® •
system, see
The message will turn off as soon as the conditions that
caused the message to be displayed are no longer
present.
For more information on the StabiliTrak
StabiliTrak
One condition is overheating, which could occur if
®
StabiliTrak activates continuously for an extended
period of time.
The message will also be displayed if the brake
system warning light is on. See Brake System
Warning Light on page 3-38.
The message could be displayed if the stability
system takes longer than usual to complete its
diagnostic checks due to driving conditions.
Also, if an engine or vehicle related problem has
been detected, and the vehicle needs service,
the message will appear. See your GM dealer.
®
System on page 4-9.
®
button or when the
®
system, see
3-61