JVC KD-DV7302 Instructions Manual page 32

5
Use the Bluetooth device to search and
connect.
On the device to be connected, enter the same PIN
code you have just entered for this unit. "CONNECT"
appears on the display.
Now connection is established and you can use the
device through the unit.
The device remains registered even after you
disconnect the device. Use "CONNECT" (or activate
"AUTO CNT") to connect the same device from next
time. (See the following and page 48.)
Searching for available devices
Perform steps 1 and 2 on page 31, then...
1
Select "SEARCH."
The unit searches and displays the list of the
available devices.
• If no available device is detected, "UNFOUND"
appears.
2
Select a device you want to connect.
3
Enter the specific PIN code of the device to
the unit.
• Refer to the instructions supplied with the device
to check the PIN code.
4
Use the Bluetooth device to connect.
Now connection is established and you can use the
device through the unit.
Connecting a special device
Perform steps 1 and 2 on page 31, then...
1
Select "SPECIAL."
The unit displays the list of the preset devices.
32
2
Select a device you want to connect.
3
Use "OPEN" or "SEARCH" to connect.
Connecting/disconnecting a registered device
1
Select "BT-PHONE" or "BT-AUDIO."
2
Select a registered device you want to
connect/disconnect.
3
Select "CONNECT" or "DISCNNCT" to connect/
disconnect the selected device.
You can set the unit to connect the Bluetooth device
automatically when the unit is turned on. (See
"AUTO CNT" on page 48.)
Deleting a registered device
1
Select "BT-PHONE" or "BT-AUDIO."
2
Select a registered device you want to delete.
3
Select "DELETE," then "YES" to delete the
selected device.