Table of Contents
Advertisement
3.2.
IP Address Configuration
Configure the IP address settings of this Switching Hub in "Interface configuration
mode." Confirm the configuration information by entering "show ip conf" in "Privi-
leged mode."
IP address configuration command
Global configuration mode
Default gateway configuration command
Global configuration mode
IP address display command
Privileged mode
Example 1: Configuration example of IP address as 192.168.0.1, subnet mask as
255.255.255.0, and default gateway as 192.168.0.254
S24GPWR> enable
S24GPWR# configure
S24GPWR(config)# ip address 192.168.0.1 255.255.255.0
S24GPWR(config)# ip default-gateway 192.168.0.254
S24GPWR(config)# end
S24GPWR# show ip conf
MAC Address
IP Address
Subnet Mask
Default Gateway : 192.168.0.254
S24GPWR#
Note:
Unless you configure these settings, you cannot use remotely connect to the
Switching Hub via Telnet or the web management function. Be sure to config-
ure. If you are unsure of the settings, consult the network administrator. Any
IP addresses on the local network must be unique, and no duplication is
allowed. In addition, you need to set the subnet mask and the default gate-
way, which are the same for other devices on the same subnet using this
Switching Hub.
: xx:xx:xx:xx:xx:xx
: 192.168.0.1
: 255.255.255.0
Fig. 3-2 Display of the IP address configuration
(show ip conf)
ip address
<ip-address> <mask> [<default-gateway>]
ip default-gateway <ip-address>
show ip conf
15
Advertisement
Table of Contents
