Chevrolet 2006 Corvette Navigation Manual page 101

Right Map [Change to] / [Show] North Up [Mode]:
These commands will cause the system to display
the North Up heading on the right map when in dual
map mode.
Right Map [Change to] / [Show] Heading Up [Mode]:
These commands will cause the system to display
the Vehicle Up heading on the right map when on the
map screen and in dual map mode.
Right Map [Change Map] Direction: This command
will cause the system to change from North Up to
Heading Up or from Heading Up to North Up.
[Show/Change to] Dual Map Mode: This command
will cause the system to change the map display to dual
map mode.
[Show/Change to] Single Map Mode: This command
will cause the system to change the map display to
single map mode.
[Change to] 3D Map [Mode]: This command will
cause the system to change the map display to the
3-dimensional map.
[Change to] 2D Map [Mode]: This command will
cause the system to change the map display to the
2-dimensional map.
Destination Commands
Home, Go Home: These commands will cause the
system to enter the Home destination as a waypoint or
final destination, if a home destination has been stored.
Go to Starting Point, Previous Starting Point:
These commands will cause the system to enter the
last available starting point as a waypoint or final
destination.
[Go to] Previous Destination: This command will
cause the system to enter the last available destination
as a waypoint or final destination, if one is available.
[Go to] Preset Destination [Number] (number):
This command will cause the system to go to the preset
destination number. This preset destination can be
chosen as a waypoint or a destination. There must be a
location stored in the preset destination number that
is chosen. For example, first store a location in
Preset Destination 3. Say "Go to Preset Destination 3."
The system will go to Preset Destination 3 and
prompt you to choose it as a waypoint or destination.
Add [to] Waypoint: This command will cause the
system to add the current marked point as a waypoint.
This command is used after the following commands
have been used: Home, Go to Starting Point, Go to
Previous Destination.
4-5