Installation Instructions; Safety Precautions - Panasonic CS-C12DKU Service Manual

CS-C9DKU CU-C9DKU / CS-C12DKU CU-C12DKU

10 Installation Instructions

1. Philips screw driver
2. Level gauge
3. Electric drill, hole core drill
(ø2 3/4")
4. Hexagonal wrench (5/32")

10.1. Safety Precautions

Read the following "SAFETY PRECAUTIONS" carefully before installation.
Electrical work must be installed by a licensed electrician.
The caution items stated here must be followed because these important contents are related to safety. The meaning of each
indication used is as below. Incorrect installation will cause harm or damage, and the seriousness is classified by the following
indications.
The items to be followed are classified by the symbols:
Carry out test running to confirm that no abnormality occurs after the installation. Then, explain to user the operation, care and
maintenance as stated in instructions. Please remind the customer to keep the operating instructions for future reference.
1. Engage dealer or specialist for installation. If installation done by the user is defective, it will cause water leakage, electrical shock or fire.
2. Install according to this installation instruction strictly. If installation is defective, it will cause water leakage, electrical shock or fire.
3. Use the attached accessories parts and specified parts for installation. Otherwise, it will cause the set to fall, water leakage, fire or
electrical shock.
4. Install at a strong and firm location which is able to withstand the set's weight. If the strength is not enough or installation is not properly
done, the set will drop and cause injury.
5. For electrical work, follow the local national wiring standard, regulation and this installation instruction. An independent circuit and single
outlet must be used. If electrical circuit capacity is not enough or defect found in electrical work, it will cause electrical shock or fire.
6. Use the UL listed or CSA approved AWG16 wire (or heavier wire) and connect tightly for indoor/outdoor connection. Connect tightly and
clamp the wire so that no external force will be acted on the terminal. If connection or fixing is not perfect, it will cause heat-up or fire at
the connection.
7. Wire routing must be properly arranged so that control board cover is fixed properly. If control board cover is not fixed perfectly, it will
cause heat-up at connection point of terminal, fire or electrical shock.
8. When carrying out piping connection, take care not to let air substances other than the specified refrigerant go into refrigeration cycle.
Otherwise, it will cause lower capacity, abnormal high pressure in the refrigeration cycle, explosion and injury.
Required tools for Installation Works
5. Spanner
6. Pipe cutter
7. Reamer
8. Knife
This indication shows the possibility of causing death or serious injury.
This indication shows the possibility of causing injury or damage to properties only.
Symbol with white background denotes an item that is PROHIBITED.
9. Gas leak detector
10. Measuring tape
11. Thermometer
12. Megameter
34
13. Multimeter
14. Torque wrench
13.3 lbf.ft
31.0 lbf.ft
40.6 lbf.ft
15. Vacuum pump
16. Gauge manifold