Download Print this page

ENFORCER E-961-S50TB Manual

Miniature single photobeam

 Small size for a less conspicuous installation

 Simple to install

 Built-in AGC control to filter out lighting

disturbances

 Signal strength indicator for easier alignment

E-961-S50TB

Miniature Single Photobeam

Manual

 LED indicators for power, signal strength,

and alarm

 Weatherproof for outdoor as well as indoor

use (IP65)

 Mounting hardware included

Table of Contents

Need help?

Do you have a question about the E-961-S50TB and is the answer not in the manual?

Page 1 E-961-S50TB Miniature Single Photobeam Manual  Small size for a less conspicuous installation  LED indicators for power, signal strength, and alarm  Simple to install  Weatherproof for outdoor as well as indoor  Built-in AGC control to filter out lighting...
Page 2 The E-961-S50TB is weather-proof, and comes with a built-in AGC control circuit that helps to filter out possible disturbance caused by local lighting conditions.
Page 3 ENFORCER Miniature Single Photobeam Sample Installation: NOTE: Do not mount the E-961-S50TB where it is exposed to direct sunlight to prevent damage to the sensor. NOTE: For best operation, there should be a minimum of 40 inches (1 meter) between the transmitter and receiver.
Page 4 ENFORCER Miniature Single Photobeam Troubleshooting:  Object may have a reflective surface which confuses the Sensor does not detect the object sensor. Try changing the angle of the sensor  Ensure that the power is connected Green power LED does not turn on ...