Table of Contents
Advertisement
Assembly Step 4
Attach the Chain
& Rail Support Bracket
• Remove the chain end from the carton and fasten
it to the trolley with a master link from the
hardware bag. See master link procedure,
Figure 1.
• With the trolley against the screwdriver, dispense
the chain around the pulley.
• Proceed back around the rail to the opener,
Figure 2. Guide the chain around the chain
spreader and sprocket. Be sure sprocket teeth
engage the chain.
• Continue forward to the trolley threaded shaft,
Figure 3.
• Use the second master link to connect the chain
to the flat end of the shaft. If necessary, loosen the
outer nut on the trolley to obtain more chain slack.
Check to make sure the chain is not twisted.
• Remove the screwdriver.
Figure 1
Master Link Procedure:
Push pins of master link bar through
chain end and hole in front end of
trolley. Push cap over pins and past
notches. Slide clip-on spring over
cap and into notches until both pins
are securely locked.
To attach the rail support bracket:
• Position the rail support bracket on the opener.
• Attach the bracket to the rail with 1/4"20x5/8" hex
screws and lock washers.
• Attach the bracket to the opener by inserting a
5/16"-18x1/2" washered screw through a hole in
each side flange and a matching hole in the
bracket. Complete the connection by inserting the
#8-32x3/8" screw through the back flange and the
hole in the rail support.
Hardware Shown Actual Size
Hex Screw
Washered Screw
1/4"-20x5/8"
5/16"-18x1/2"
Chain
Chain
Pulley
Bracket
Install Chain
In This Direction
Screw
Lock Washer
#8-32x3/8"
9
WARNING
Serious injury can result if fingers become
entangled in moving opener sprocket. Attach
sprocket cover securely. Never operate opener
while your hand is near the opener sprocket.
Chain
CAUTION
Spreader
Figure 2
of Trolley
Master Link
Threaded
Clip-On Spring
Master
Link Cap
AVERTISSEMENT
Master
Link Bar
1/4"-20x5/8" Hex Screws
with Lock Washers
5/16"-18x1/2"
Washered Screw
Rail Support
Bracket
Sprocket
Opener
Master Link
Clip-On Spring
Master
Link Cap
Flat End
Shaft
Chain
Rail
Pin Notch
Pin
Figure 3
Trolley
ATTENTION
#8-32x3/8"
Screw
5/16"-18x1/2"
Washered Screw
Opener
Back Flange
Opener
Side Flange
Advertisement
Table of Contents
