Disassembly
When the hood is installed to operate in recirculation mode, the addition of charcoal filters
(supplied in kit) is required. FIG 4 shows the standard filter used when the hood is installed for
exterior discharge.
FIG 4
FIG 5
Standard Filter – Exterior Discharge
Recirculation – Charcoal Filter Added
The charcoal filter is held in place with four securing clips (Included with charcoal filter) as shown
in FIG 5 above.
Remove filters to access the internal blower motors. FIG 6 shows that the motor assembly
consists of two motors, one which rotates in a Clockwise rotation (Below right) and the other in a
counter-clockwise rotation (Below left). Each motor is connected separately to the control housing
by the use of a 4-wire Molex disconnect plug (Inset).
FIG 6
Recirculation installation shown
9