Viking DCH3042 Service Manual page 12

Disassembly
To access internal controls, remove left and right side trim held in place with (2) Phillips head screws shown in
FIG 14 and Fig 15.
FIG 15
FIG 14
There are five Phillips head screws that hold the control panel in place. One on each side, one in the center and
two that hold the filter supports in place, FIG 16 shows one of the side screws and filter support screw.
The screw circled in red holds the component compartment to the main frame and must be removed to access
the switches and thermostats.
FIG 16
With the screws removed, remove the power and motor connection mounting plate from the hood. Internal
wiring of the power connections is now accessible as shown in FIG 17.
FIG 17
Power input
Internal Motor connection
12