Hotpoint Ariston LFF 8M113 7 Operating Instructions Manual page 15

Advice regarding the first wash cycle
After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack (if any).
Water softener settings
Before starting the first wash cycle, set the hardness lev-
el of
the water from the mains supply. (see chapter Rinse
aid and refined salt).
First load the softener tank with water, then introduce about
1 kg of salt. It is perfectly normal for water to flow out.
As soon as this procedure is complete, run a wash cycle.
Only use salt that has been specifically designed for dish-
washers.
After the salt has been poured into the machine, the LOW
*
SALT indicator light switches off.
If the salt container is not filled, the water softener and the
heating element may be damaged as a result.
Technical data
width 60 cm
Dimensions height 85 cm
depth 60 cm
Capacity 14 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
Water supply pressure
7,25 – 145 psi
Power supply voltage See appliance data plate
Total absorbed power See appliance data plate
Fuse See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EU Waste Electrical
and Electronic Equipment
(WEEE)
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
Transportation
Unload all crockery from the dishwasher and secure moving
parts.
All water remaining inside the appliance should be drained
as follows:
make sure that the water tap is open and select the ECO cycle.
The cycle will begin. After 5 minutes, end the cycle by pressing
the ON/OFF button until you hear a beep and the indicator lights
switch off. Wait for approximately 5 minutes before uninstalling
the appliance. Shut off the tap and disconnect the inlet and
drain hose.
The appliance should only be moved in an upright position, in
order to prevent any water remaining inside the appliance from
damaging dishwasher components.
Leaving the machine unused for extended periods/
Freezing protection
If the appliance is situated in a location which is at risk of freezing,
or if you intend to be away for extended periods of time (e.g.
holiday home) , empty the appliance completely.
- Carry out the process used to drain all water remaining inside
the appliance (see Transportation).
- Disconnect the appliance from the electricity supply and shut
off the water tap.
- Leave the appliance door ajar.
- When you return, run a cycle while the dishwasher is empty.
*
Only available in selected models.
(depending on the
EN
.
15