Channel Selection - Palsonic 6830G Owner's Manual

OPERATION

Channel selection

You can watch TV programmes being broadcast on the preset channels.
To watch a TV programme
You can select your desired TV program by one of the following methods.
Using the direct select buttons
To select a one-digit position number (0-9)
METHOD 1: Press the button and the screen displays "X- -", wait for 2
seconds and the channel is selected.
Press 0 button and the screen displays "0- -", then press 0 button
METHOD 2:
again, the screen displays "00-" then press the numbers. (The
period of two-press must be within 2 seconds).
To select a two-digit position number (10-99)
METHOD 1: Press these two numbers and the screen displays "XX -", (The
period of two-press must be within 2 seconds). Wait for 2
seconds and the channel is selected.
Press 0 button first, than press these two numbers, the screen
METHOD 2:
displays "0XX", the channel is selected. (The period of
two-press must be within 2 seconds).
To select a three-digit position number (100-255)
Press these three numbers and the screen displays "XXX" the channel
is selected. (The period of two-press must be within 2 seconds).
NOTE: If the input number is over 255, the screen will remain at the
current viewed program.
Using the CH buttons
Press CH
CH
Using the PREVIOUS channel button (
When there are no menus on the screen, pressing the
MENU button) can swap the current viewed
channel with the previous one. For example, the
channel you previously watched is 11, the present
channel is 2, press the
channel 11, press the
to channel 2.
Using the channel SCAN button
Press SCAN button, the set will scan the channels from first channel to higher channels
one by one, every program will be displayed for about 3 seconds and then go on scanning
until all programs are scanned over and then return to your former viewed program.
During the scanning, press SCAN button again, the set will return to your former viewed
program.
to select lower position numbers;
to select higher ones.
)
button on the remote controller (below the
button again it will return
button, it will return to
12
After 2
X--
seconds
X
X--
XX-
XX
X--
XX-
XXX
3
2
1
11
2