Operating Instructions - Kärcher G 2800 OC User Manual

STEP 1:
Pull back the spring loaded collar at the spray
gun and insert the high pressure hose.
Release the collar and push the high pressure
hose until the collar clicks.
CAUTION
Engine shipped without oil. Before starting
engine, fi ll with oil. Do not over-fi ll. Do not run
the engine with a high or low oil level as this
can cause engine damage.
If you have further questions regarding the
engine, please refer to the engine manual
included with the unit.
STEP 2:
Check oil level. Insert and remove dipstick
without screwing it into the fi ller neck. Check
the oil level shown on the dipstick.
FULL / MAX
ADD / MIN
Be sure the machine is level when checking
the oil level. (Refer to the engines operating
manual for seasonal grades).
We recommend that the oil be changed after
the fi rst 5 hours of use, then once every 50
hours.
STEP 3:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.

OPERATING INSTRUCTIONS

Do not add oil to the gasoline.
STEP 4:
Pull back the spring loaded collar at the high
pressure outlet and insert the high pressure
hose.
Release the collar and push the high pressure
hose until the collar clicks.
STEP 5:
Connect garden hose to unit`s water inlet.
STEP 6:
Connect garden hose to the cold water source
and turn water completely on.
Do not use hot water.
STEP 7:
Unlock the trigger gun safety lock. Trigger the
gun to eliminate trapped air, wait for a steady
fl ow of water to emerge from the spray nozzle.
STEP 8:
Open fuel valve. Pull the choke rod to the ON
position (on a warm engine, leave the choke
rod in the OFF position).
STEP 9:
Move the engine stop switch to the ON posi-
tion.
English 7