Overview; Windows Installation - Linksys NMH300 Quick Installation Manual

Overview

IMPORTANT:
drive available to install in the Media Hub.
You can use a new or previously used hard disk drive. If you use a previously
used hard disk drive, all data on that drive will be erased during installation. If
you want to keep any of the data, back up the drive before installation of the
Media Hub.
The Installation section explains how to install the Media Hub and set up your
computer for access to the Media Hub. For a Windows computer, proceed to the
Windows Installation section. For a Mac, proceed to the Mac Installation section.
The Setup of Additional Computers section explains how to set up additional
computers for access to the Media Hub. The Tools section describes different
ways to take advantage of the Media Hub's features.

Windows Installation

NOTE:
enhance the functionality of the product. Software firewalls installed
on your computer can block this communication between the
programs and the Media Hub. It is strongly recommended that you
disable your firewall software prior to installation of the Media Hub.
1.
Make sure the Media Hub is
powered off.
Insert the Setup Wizard CD-ROM
into your computer's CD-ROM
drive. The Setup Wizard should
run automatically, and the video
should begin automatically. If it
does not, click Start and then
Run. In the field provided, enter
D:\startinstall.exe (if "D" is the
letter of your CD-ROM drive).
2.
An introductory video plays. To bypass the video, click the X button in the
upper right corner of the screen.
2
You must have a 3.5-inch, Serial-ATA (SATA) hard disk
The Media Hub Setup Wizard installs several programs that
Media Hub