Epson WF-100 Start Here

Start Here

© 2014 Seiko Epson Corporation.
All rights reserved.
Printed in XXXXXX
Do not open the ink cartridge package until you are ready
to install it in the printer. The cartridge is vacuum packed
to maintain its reliability.
Do not connect a micro USB cable
unless instructed to do so.
c
Important; must be observed to avoid damage to your equipment.
1
A
Windows
Contents may vary by location.
Maintenance box: If the maintenance box full error appears,
replace it. See the "Replacing Maintenance Box" section.
B
Remove all protective materials.
Q
For the initial setup, make sure you use the ink cartridges that came
with this printer. These cartridges cannot be saved for later use. The
initial ink cartridges will be partly used to charge the print head. These
cartridges may print fewer pages compared to subsequent ink cartridges.
2
A
Connect the power cord and plug in.
B
Turn on.
Select a language.
C
D
Remove from the package and then remove only the yellow tape.
E
Remove the caps and dispose of them correctly.
c
Do not touch the sections.
F
Open.
G
Insert diagonally and push.
c
Make sure you insert the black cartridge into the left holder, and the
color cartridge into the right holder.
H
Close.
I
Press OK. Charging ink is started.
J
Charging ink takes about 4 minutes. Wait until a completion message is
displayed.
K
Check the home screen on the LCD display.
Q
The capacity level of the maintenance box decreases. The initial
maintenance box is partly filled after charging the print head.
3
A
B
Load A4 size paper for the test print.
Check the paper size and type.
C
4
Windows
Q
If the Firewall alert appears, allow access for Epson applications.
Windows (No CD/DVD drive)
Mac OS X
http://epson.sn
Visit the website to install the software and configure network settings.
iOS / Android
http://epson.sn
Visit the website to install the Epson iPrint application and configure network
settings.