Traxxas 57046-4 Owner's Manual page 15

RADIO SYSTEM CONTROLS
Neutral
RADIO SYSTEM RULES
• Always turn your
1
TQi transmitter on
first and off last. This
procedure will help to
prevent your model
from receiving stray
signals from another
Always turn your
transmitter, or other
transmitter on first.
source, and running
out of control. Your model has electronic fail-safes to prevent this
type of malfunction, but the first, best defense against a runaway
model is to always turn the transmitter on first, and off last.
• Always use new or freshly charged batteries for the radio system.
Weak batteries will limit the radio signal between the receiver and the
transmitter. Loss of the radio signal can cause you to lose control of
your model.
• In order for the transmitter and receiver to bind to one another, the
receiver in the model must be turned on within 20 seconds of turning on
the transmitter. The transmitter LED will flash fast red indicating a failure
to link. If you miss it, simply turn off the transmitter and start over.
• Always turn on the transmitter before plugging in the battery.
RADIO SYSTEM BASIC ADJUSTMENTS
Throttle Neutral Adjustment
The throttle neutral adjustment is located on
the transmitter face and controls the forward/
reverse travel of the throttle trigger. Change the
adjustment by pressing the button and sliding
it to the desired position. There are two settings
available:
Brake/Reverse 50/50: Allows equal travel for both acceleration and reverse.
70/30: Allows more throttle travel (70%) and less reverse travel (30%).
Note: We strongly recommend to leave this control in its factory
location until you become familiar with all the adjustments and
capabilities of your model. To change the throttle neutral adjust
position, turn the transmitter off before adjusting the neutral position.
Forward
You will need to reprogram your electronic speed control to
recognize the 70/30 setting. Turn to ESC Setup Programming on
page 18 for instructions.
Steering Trim
The electronic steering trim located on the face
2
of the transmitter adjusts the neutral (center)
point of the steering channel.
Note: Traxxas Stability Management (TSM) must be completely turned
off while adjusting steering trim. See page 17 for TSM adjustments.
Multi-Function Knob
Plug in the batteries.
The Multi-Function knob can be programmed
to control a variety of functions. From the
factory, the Multi-Function knob controls
Traxxas Stability Management (TSM). For more
detail on TSM, refer to page 17.
TQ RADIO & BRUSHLESS POWER SYSTEM
i
5
DCB M41 WIDEBODY • 15