Specifications - Makita PJ7000 Instruction Manual

ENGLISH (Original instructions)
1-1. Pointer
1-2. Stopper
1-3. Adjusting screw
1-4. Rubber spike
2-1. Lock lever
2-2. Angle guide
2-3. Knob
2-4. Scale
2-5. Pointer
2-6. Tighten
2-7. Loosen
3-1. Knob
3-2. Down
3-3. Up
3-4. Center of blade thickness
4-1. Fence

SPECIFICATIONS

Max. grooving depth
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting crescent shaped slots for
the placement of flat wooden dowels or biscuit by a
plunging action.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
4-2. Lock lever
4-3. Angle scale
4-4. Tighten
4-5. Loosen
5-1. Lock lever
5-2. Pointer
5-3. Angle scale
5-4. Center of blade thickness
5-5. Blade cover
6-1. Lock lever
6-2. Pointer
6-3. Angle scale
6-4. Set plate
6-5. Thickness of set plate
6-6. Center of blade thickness
6-7. Blade cover
Model
Type of blade
Plate joiner blade
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 86 dB (A)
pA
) : 97 dB (A)
WA
ENE013-1
Vibration
The vibration
determined according to EN60745:
Work mode : cutting grooves in MDF
ENF002-2
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
The declared vibration emission value may also be
•
ENG905-1
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
7-1. Set plate
8-1. Slide switch
9-1. Lock nut
9-2. Plate joiner blade
9-3. Inner flange
9-4. Clamp screw
9-5. Blade cover
9-6. Loosen
9-7. Tighten
9-8. Shaft lock
10-1. Dust bag
10-2. Fastener
10-3. Dust nozzle
25-1. Exhaust vent
25-2. Inhalation vent
PJ7000
Plate joiner
20 mm
11,000
302 mm
2.5 kg
/II
total value (tri-axial
2
) : 2.5 m/s or less
h
2
ENG900-1
vector sum)
ENG901-1