Using Legacy Dv-68K And Tk Series Interfaces With The Sprite - MedeaWiz Sprite User Manual

MedeaWiz® Sprite
Team Kingsley LLC

Using legacy DV-68K and TK series interfaces with the Sprite

The Sprite can work with the older DV-68K and TK-68K or TK-69K series of pushbutton
controllers.
For the DV-68K you will need to set the baud rate of the Sprite to 4800.
For the TK series, depending on the settings and installed program in the TK circuit board, you
will most likely need to update the program in the TK to 9600 baud and the Sprite "End Of File"
marker byte, 0xEE.
In any case you will need to purchase or fabricate the adaptor cable shown below.
23 | P a g e