Configuration; Configuration Procedure; Integrating The Inverter Into The Network - SMA STP 15000TL-30 Operating Manual

SMA Solar Technology AG
8

Configuration

8.1

Configuration Procedure

Once you have commissioned the inverter, you may have to adjust various settings via the rotary
switches in the inverter or via a communication product. This section describes the procedure for
configuration and gives an overview of the steps you must perform in the prescribed order.
Procedure
1. If required, integrate the inverter in a Speedwire
network.
2. To manage the PV system data or to set the in-
verter parameters, capture the inverter in a com-
munication product.
3. Change the system time and system password.
4. If required, register the inverter in Sunny Portal.
5. Set the active power limitation in case of PV sys-
tem control failure.
6. If required, reduce the attenuation of ripple con-
trol signals.
7. For partially shaded PV modules and depending
on the given shading situation, you should set
the interval at which the inverter optimizes the
MPP of the PV system.
8.2

Integrating the Inverter into the Network

If the router supports DHCP and DHCP is enabled, the inverter will automatically be integrated into
the network. You will not need to carry out network configuration.
If the router does not support DHCP, automatic network configuration will not be possible and you
will need to use the SMA Connection Assist to integrate the inverter into the network.
Requirements:
☐ The inverter must be in operation.
☐ There must be a router with Internet connection in the local network of the system.
☐ The inverter must be connected to the router.
Procedure:
• Integrate the inverter into the network by means of the SMA Connection Assist. Download the
SMA Connection Assist and install it on the computer (see www.SMA-Solar.com).
Operating Manual
See
Section 8.2, page 35
Manual of the communication product
at www.SMA-Solar.com
Manual of the communication product
at www.SMA-Solar.com
Manual of the SMA Speedwire/Web-
connect data module
Section 8.4, page 36
Section 8.6, page 37
Section 8.7, page 38
STP15-25TL-30-BE-en-13
8 Configuration
35