Team Corally RACE 60 Instruction Manual page 13

Locate the flowcharts show the entire programming menu. It is highly recommended to have
these flowcharts handy while learning to operate this charger.
There are two main ways in which to set the charger:
(1). A memory profile is available for setting and storing pertinent information for up to 10
different batteries. Once a battery's information is stored into a memory it will be retained
until changed again manually. Recalling a battery's memory number makes the charger
instantly ready to go!
(2). If you do not use the battery memories, this charger can be manually set before each use.
For following step, all are basing on manually set
3. BATT/PROGRAM Select
Press INC and DEC to go through all the programs and press
START/ENTER to enter LiPo BATT Program.
4. Mode Select
Press INC and DEC to go through all the modes and press START/
ENTER to enter LiPo Balance Charge Mode.
5. Battery Setting
Press START/ENTER, the current value will start to blink, press INC
and DEC to change the value and press START/ENTER to confirm
your setting. At the same time, the battery cells number will start
to blink, press INC and DEC to change the value and press START/
ENTER to confirm your setting.
6. Program Start
Press and hold START/ENTER for 3 seconds to start the program.
The charger is detecting the battery cell.
R shows the number of cells detected by the charger and S is the
number of cells set by you at the previous screen. If both numbers
are not identical, press STOP to go back to previous screen to
recheck the number of cells before going ahead.
OPERATING PROGRAM
13