Operating Program - Team Corally RACE 60 Instruction Manual

OPERATING PROGRAM

Here is the detailed procedure to make the charger work. All the screens and operations
will take Li-Po BALANCE CHARGE program for example:
1. Connection
A) Connecting to power source
It is an AC charger only.
Please insert the AC power cord to the wall socket (100-240V) directly to power it on.
B) Connecting the battery
Important: Before connecting a battery it is absolutely essential to check one last
time that you have set the parameters correctly. If the settings are incorrect, the
battery may be damaged, and could even burst into flames or explode. To avoid
short circuits between the banana plugs, always connect the charge leads to the
charger first, and only then to the battery. Reverse the sequence when disconnect-
ing the pack.
C) Balance Socket
In default setting, for safety issue, it requests to use balance charging wire with
balance board to charge Lithium batteries in all modes.
If the charging battery has no balance wire, please disable this function in system
setting program as following.
BATT/PROGRAM
SYSTEM SETTING->
The balance wire attached to the battery must be connected to the charger with the
black wire aligned with the negative marking. Take care to maintain correct polarity!
(See the wiring diagram below.)
This diagram shows the correct way to connect your battery to the Race 60 while
charging in the balance charge program mode.
12
START
Bal. Connection
ON
ENTER
WARNING
Failure to connect as shown in this diagram will
damage this charger.
To avoid short circuit between the charge lead
always connect the charge cable to the charger
first, then connect the battery.
Reverse the sequence when disconnecting.
START
Bal. Connection
OFF
INC/DEC