Removing The Speaker; Replacing The Speaker - Dell Precision R5400 Service Manual

Back to Contents Page
Speaker
Dell Precision™ R5400 Service Manual
Removing the Speaker
Replacing the Speaker
CAUTION: Only trained service technicians are authorized to remove the computer cover and access any of the components inside the computer.
Before working inside the computer, read the safety information that shipped with the computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Speaker
1. Perform the steps in Before Working on Your
2. Disconnect the speaker cable from the control panel board.
NOTICE: Pull on the connector to disconnect the cable. Do not pull on the cable to unseat the connector. Doing so can damage the cable.
1 control panel cable
3 speaker cable
5 speaker release tab
3. To gain access to the speaker, disconnect the control panel cable from the control panel board.
4. Press back on the speaker release tab so that you can slide the speaker up out of the chassis.
Replacing the Speaker
1. Slide the speaker down into the retaining brackets until the release tab snaps into place.
2. Connect the speaker cable to the control panel board.
3. Connect the control panel cable to the control panel board.
Back to Contents Page
Computer.
2 control panel board
4 retaining brackets (2)
6 speaker