Dell Inspiron 510m Service Manual page 16

14.1-Inch Display Panel
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
1. Follow the instructions in "Preparing to Work Inside the
2. Remove the keyboard.
3. Remove the display bezel.
4. Remove the eight M2 x 5-mm screws from each side of the display- panel adapter rails.
5. Lift the display panel, and rotate the display panel out of the display cover.
6. Remove the four M2 x 3-mm screws from each side of the display panel to remove the adapter rails.
When reinstalling the adapter rails to the replacement display panel, orient the rails so that the "This side up" markings are facing you, and then
reattach the rails with the M2 x 3-mm four screws. (The "This side down" markings on the rails should be visible from the backside of the display panel.)
1 14.1-inch display panel
2 adapter rails (2)
3 M2 x 3-mm screws (4)
4 "This side up" markings
7. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.
8. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
Computer."