Dell XPS 600 Service Manual page 50

5. Connect the other end of the data cable to the connector labeled "DSKT" on the
6. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
7. Close the computer
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into your
computer.
8. Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
9. Enter the system setup program
10. Verify that your computer works correctly by running the Dell Diagnostics.
Media Card Reader (Optional)
Removing a Media Card Reader
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.
1. Follow the procedures in
2. Disconnect the USB cable on the back of the media card reader from the internal USB connector on the system board.
3. Press in on the tabs on each side of the media card reader and slide the card reader out of the adapter.
cover.
and update the appropriate Diskette Drive option.
"Before You Begin."
system board.