Samsung VP-M2050S(B) Owner's Instruction Book page 126

ENGLISH
Troubleshooting
Symptom Possible Causes
Focus does not adjust Focus is set to manual mode
automatically Recording was done in a
dark place
Lens is covered with
condensation
The Memory Card will The Memory Card is in wrong
not load properly position
Something fills in the MUILTI
CARD slot
Colour balance of picture White balance adjustment is
is not natural required
Digital zoom does not The effect(Digital special
work effect) is applied
Files stored in the Memory Card is protected
Memory Card cannot be File is locked
deleted
Images on the LCD Ambient is too bright
monitor appear dark Ambient temperature is too
low
Rear of the LCD monitor Prolonged use of LCD
is hot monitor
Play, rewind and fast The Photo Mode is selected
forwarding do not work
Memory Card cannot be
The Video Mode is selected
played back (Photo mode)
No picture is taken when
Not enough free memory
is fully pressed
space is remained
Memory Card is formatted by
different devices
Light is forced to cancel
Built-in Light will fire
Light is not available for
recording
Cannot Record a video The 'Photo Mode' is selected
LCD monitor turns off To save power consumption,
the LCD monitor and CAM's
power turns off if there is no
button operation for a certain
period of time (depending on
operation mode), which is not
a malfunctioning
126 126
Measure
Set focus to AUTO
Use strobe or lit the place
Clear the lens and check the focus
Insert the Memory Card properly, page 33
Clear the MUILTI CARD slot
Set proper white balance, page 69
Turn off the effect(Digital special effect),
page 54
Remove the protection tab of Memory Card
(except MMC)
Remove the lock on the file, page 86
Adjust the brightness and angle of LCD
Low temperatures might produce a dark
LCD display
This is not a malfunction
Close the LCD monitor to turn if off,
or turn your device off to cool down
Select 'Video Mode' and select 'Play'
Select 'Photo Mode' and select 'View'
Delete files from the Memory Card
Format the Memory Card on the CAM
Select different Flash mode, page 67
Select 'Video Mode'
Operating any button will turn the CAM on
Pressing the button once again will operate
its function
MULTI CARD
LCD
LCD LCD
Photo Mode
LCD
AUTO
33
MULTI CARD
69
54
86
LCD
LCD
LCD
Video Mode
Play
Photo Mode
View
67
Video Mode
LCD
MMC