Brother PT-2100 User Manual page 66

TROUBLESHOOTING
Problem
The P-touch labeler
stops while printing a
label.
The label is not cut
automatically.
Label files saved
previously are now
empty.
64
What to do when...
Possible Cause
Is there enough tape
remaining in the tape
cassette?
Are the batteries weak and
the AC adapter not
connected or is the AC
adapter the Brother AD-24?
Is Cut Option set to Chain or
No Cut?
Is Manual Cutting set to ON? When using Fabric Iron-On
Does the tape compartment
cover open?
Have the batteries and AC
adapter been disconnected?
Is there enough power
remaining in the batteries?
Have you used the Reset
function?
Recommendation
The striped tape indicates
you have reached the end of
the tape. Replace the tape
cassette when the striped
tape appears.
Replace all batteries or
connect the AC adapter
(Brother AD-24) directly to
the P-touch labeler.
When these options are set,
the tape is not fed after
printing the label. Check the
Cut Option setting, or hold
down the key and press
the key to feed and
cut the tape.
Tapes or Extra Strength
Adhesive Tapes, please use
scissors to cut the tape after
printing.
If so, close the tape
compartment cover
correctly.
All files stored in the internal
memory is lost if the
batteries and AC adapter are
disconnected for longer than
two minutes.
All data stored in the internal
memory is lost if the
batteries become empty.
The reset function clears all
data stored in the internal
memory, including label
files.